NOTE: Always install 2 lights even when you do not have the putting sensors.
WARNING: Lights are 12v and require a 12v transformer!
The system lighting supplied are 12v and require your local current type to be converted to 12v via a transformer.
YOU COULD BLOW THE BULBS IF NO TRANSFORMER IS FITTED PRIOR TO INSTALL.
Your system requires the supplied lighting to be used as the bulb
type provides the required IR amount for your sensors to react correctly.
Suggested replacement bulbs are Par 36 Ar 111 50W 24/25 degree halogen (2950k or above).
Please ensure if other lighting is present especially LED, that these can be switched off independently
of the system lighting (LED can cause sensor malfunctions).
To ensure clarity of ball detection it is required that internal walls are blacked out within the simulator area.
Sunlight and Daylight, must be kept out of the simulator set up.
Ensure each light is positioned directly over the centre of each sensor mat.
If no putting sensors are used, both lights must still be installed and should be 1.15m / 45″ apart.